I’ve contacted the Aeotec support, but they have basically told me to do what I’ve already done!Īnyone got suggestions, or had similar problems? This thing seems like a brick, and I just got it. I do not see the hub listed in the IDE either (because I removed it in the app.) It has been 30 minutes and it says 50 (39/79MB). The G Hub does't work well, I can't use it, its freezing, or doesn't start. After 3 hours i can install again the G Hub, but unfortunately my profiles are gone. I try to reinstall, or uninstall, but the installer doesn't work. Follow all the instructions and it gets to the downloading updates screen and seems to hang there. Yesterday, a new update coming, and my G Hub, with all of my near twenty profiles disappeard. I follow the directions to the letter and still not making it through the setup. What I get now after powering up is alternating solid blue and then alter solid green, then back to blue, repeating. The transfer from the V1 hub to the Aeotec hub is not going well. I’ve tried stop pushing the reset 1 second after turning yellow, 3 seconds, immediately, and about 20 seconds, but nothing resets this darn thing. (Power off, push in reset, plug power in with reset pushed, orange/yellow light flickers and when it goes solid I stop pushing reset). What’s interesting is that the hub although not plugged into ethernet is showing up on my network (through wifi). Since then I cannot get it to flash red/green in order to start the setup again. The certain members of Mod Division also develop the iKingsSGC Server Network Custom Plugin Suite. I had issues on the same place with the update and then it wasn’t clear if the update was done or not so in SmartThings app I removed the hub and reset the hub as per factory. The iKingsSGC Mod Division is a section of the iKingsSGC that develops modifications of the highest quality for Minecraft such as the Doctor Who Client Mod and Stargate Chevron 7 which are respectively whole games being built on-top of minecraft. I’ve tried resetting the hub as per the instructions but it doesn’t seem to reset.
0 kommentar(er)
